Manual IP Setting through Control Panelbr br On the control panel, press OK.br Use the arrow buttons to select Network config., and then press OK.br Use the arrow buttons to select CFG TCPIP, and then press OK.br Use the arrow buttons to select BOOTP, make sure the value is No, and then press OK.br Use the arrow buttons to select DHCP, make sure the value is No, and then press OK.br Use the arrow buttons to select IP BYTE 1, and then press OK.br Use the arrow buttons to change the value of IP BYTE 1, and then press OK.br Repeat steps 6 and 7 for IP BYTE 2, IP BYTE 3, and IP BYTE 4. Also, repeat steps 6 and 7 for the Subnet Mask (SM BYTE 1, SM BYTE 2, SM BYTE 3, SM BYTE 4 ) and Default Gateway (GW BYTE 1, GW BYTE 2, GW BYTE 3, GW BYTE 4).br NOTE: Example: If the IP address is 192.168.0.1br IP byte 1=192br byte 2=168br byte 3 =0br byte 4 =1br Use the Back or Cancel button to leave the Network config. menu.br Settings will take effect after Step 9 and the printer has returned to Ready.